Radicore Forum: How To » Calling List2 from a List2

Home » RADICORE » How To » Calling List2 from a List2

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Re: Calling List2 from a List2 [message #2371 is a reply to message #2370]

Mon, 16 November 2009 07:24

AJM
Messages: 2386
Registered: April 2006
Location: Surrey, UK

Senior Member

Your table layout does not identify the primary key, which is why I asked the question.

(1) What is being extracted into the $where by the 1st LIST2 task?
(2) What is being filtered out of the $where string by the 2nd LIST2 task?

That is why I asked you to step through with your debugger to see what is happening and where.

You might also want to take a look at Passing context between objects.

Tony Marston
http://www.tonymarston.net
http://www.radicore.org

Report message to a moderator

[Message index]

		Calling List2 from a List2 By: ljkbrost on Mon, 16 November 2009 04:25
		Re: Calling List2 from a List2 By: AJM on Mon, 16 November 2009 04:39
		Re: Calling List2 from a List2 By: ljkbrost on Mon, 16 November 2009 04:45
		Re: Calling List2 from a List2 By: AJM on Mon, 16 November 2009 07:24
		Re: Calling List2 from a List2 By: ljkbrost on Mon, 16 November 2009 20:04
		Re: Calling List2 from a List2 By: AJM on Tue, 17 November 2009 04:15

Previous Topic:	Use a blank controller
Next Topic:	Multiple Checkbox Control

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Dec 11 16:01:24 EST 2025

Total time taken to generate the page: 0.00912 seconds