Radicore Forum
Fast Uncompromising Discussions. FUDforum will get your users talking.
Home » RADICORE development » Workflow » Using Pipe3 to model workflow (Petrinet modeling)
Using Pipe3 to model workflow [message #2756] Thu, 21 July 2011 16:09 Go to next message
grim is currently offline  grim
Messages: 11
Registered: July 2011
Location: Surrey, UK
Junior Member
I was very interested in how workflow is implemented in Radicore and read a bit about Petrinets etc. I downloaded the Pipe3 program to model my workflow. I can create the nets OK and save them, but I cannot open them up again - I get a java error.

I know its outside the scope of Radicore, I was just wondering if anyone else had experienced this and had solved this problem?

Thanks and regards

Graham Jones

Report message to a moderator

Re: Using Pipe3 to model workflow [message #2757 is a reply to message #2756] Fri, 22 July 2011 04:52 Go to previous messageGo to next message
AJM is currently offline  AJM
Messages: 2386
Registered: April 2006
Location: Surrey, UK
Senior Member
You should report that error to the authors of that software. You can create a new issue at http://code.google.com/p/pipe-3-development/issues/list

Tony Marston
http://www.tonymarston.net
http://www.radicore.org

Report message to a moderator

Re: Using Pipe3 to model workflow [message #2759 is a reply to message #2756] Fri, 22 July 2011 11:10 Go to previous message
grim is currently offline  grim
Messages: 11
Registered: July 2011
Location: Surrey, UK
Junior Member
Ta. Done.

Cheers

Gj

Report message to a moderator

Previous Topic: creating a system that uses workflow
Next Topic: Workflow implementation question
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sat Nov 08 15:00:14 EST 2025

Total time taken to generate the page: 0.01035 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.2.0.
Copyright ©2001-2025 FUDforum Bulletin Board Software