Radicore Forum: Transaction Patterns » Using fillcolour in an output3 pattern

Home » RADICORE development » Transaction Patterns » Using fillcolour in an output3 pattern

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Re: Using fillcolour in an output3 pattern [message #7858 is a reply to message #7857]

Mon, 29 July 2024 04:50

AJM
Messages: 2382
Registered: April 2006
Location: Surrey, UK

Senior Member

Take at look at this page. That will show you some sample output which I have built into the framework. Just run the "Nav Buttons (PDF)" task and you can see the output, then look at the code.

You need to ensure that the style you have added to the pdf.styles.inc file is actually mentioned in your report structure file.

Tony Marston
http://www.tonymarston.net
http://www.radicore.org

Report message to a moderator

[Message index]

		Using fillcolour in an output3 pattern By: htManager on Wed, 11 May 2022 17:30
		Re: Using fillcolour in an output3 pattern By: AJM on Thu, 12 May 2022 04:27
		Re: Using fillcolour in an output3 pattern By: AJM on Sat, 27 July 2024 12:11
		Re: Using fillcolour in an output3 pattern By: htManager on Sun, 28 July 2024 06:49
		Re: Using fillcolour in an output3 pattern By: AJM on Mon, 29 July 2024 04:50
		Re: Using fillcolour in an output3 pattern By: htManager on Mon, 29 July 2024 08:50

Previous Topic:	_cm_outputMulti() - "parent-child-grandchild"
Next Topic:	Introduction to Transaction Patterns within Radicore

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri May 09 23:57:49 EDT 2025

Total time taken to generate the page: 0.03947 seconds