Radicore Forum
Fast Uncompromising Discussions. FUDforum will get your users talking.

Home » RADICORE development » Transaction Patterns » Output 3 - _cm_output_multi()
Re: Output 3 - _cm_output_multi() [message #7635 is a reply to message #7634] Wed, 11 August 2021 16:09 Go to previous messageGo to previous message
htManager is currently offline  htManager
Messages: 343
Registered: May 2014
Senior Member
If I understand you right then replacing the primary key values as I did is the right way to get the result/report I want.

Only if the primary key field names of both the outer and the inner entity are the same then there would be no problem. Is this correct?

All I have to do in the future is to take care of these constructions and to replace the primary key field names in _cm_initialise(). No problem. Thank you.
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: POPUP3 not working
Next Topic: Introduction to Transaction Patterns within Radicore
Goto Forum:
  


Current Time: Sun Nov 28 16:29:25 EST 2021

Total time taken to generate the page: 0.01060 seconds