Radicore Forum: Framework » PDF

Home » RADICORE development » Framework » PDF - drawing with lines

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Re: PDF - drawing with lines [message #7909 is a reply to message #7908]

Wed, 19 February 2025 11:33

htManager
Messages: 452
Registered: May 2014

Senior Member

Instead of drawing lines I would have another solution:
To do this I would have to put a field over an image. However, the field is displayed either above or below the image. Depending on how I fill out the structure file.
$structure['multi10']['fields'][1][] ...
$structure['multi10']['fields'][2][] ...

Is it possible to layer one on top of the other?
I have attached a drawing.

Attachment: wurfbild.jpg
(Size: 16.91KB, Downloaded 51 times)

Report message to a moderator

[Message index]

		PDF - drawing with lines By: htManager on Fri, 14 February 2025 10:37
		Re: PDF - drawing with lines By: AJM on Sun, 16 February 2025 05:05
		Re: PDF - drawing with lines By: htManager on Sun, 16 February 2025 05:43
		Re: PDF - drawing with lines By: htManager on Wed, 19 February 2025 11:33
		Re: PDF - drawing with lines By: AJM on Thu, 20 February 2025 04:25
		Re: PDF - drawing with lines By: htManager on Thu, 20 February 2025 06:11
		Re: PDF - drawing with lines By: htManager on Thu, 20 February 2025 10:15
		Re: PDF - drawing with lines By: AJM on Sat, 22 February 2025 05:02

Previous Topic:	Tab order in Radicore screen
Next Topic:	Introduction to the Radicore framework

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Feb 22 21:43:24 EST 2025

Total time taken to generate the page: 0.01257 seconds