Radicore Forum: Bug Reports » getInitialDataMultiple does not deal with ') OR (' in $where parameter

Home » RADICORE development » Bug Reports » getInitialDataMultiple does not deal with ') OR (' in $where parameter

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Re: getInitialDataMultiple does not deal with ') OR (' in $where parameter [message #1154 is a reply to message #1140]

Tue, 30 October 2007 16:53

alrobertson
Messages: 9
Registered: October 2007
Location: Vancouver

Junior Member

The fix worked for my purposes but it broke "dict_table_s01" since it does not expect the array. I suppose any call to a _cm_getInitialDataMultiple() that does not expect the array will be broken.

Report message to a moderator

[Message index]

		getInitialDataMultiple does not deal with ') OR (' in $where parameter By: alrobertson on Wed, 24 October 2007 19:22
		Re: getInitialDataMultiple does not deal with ') OR (' in $where parameter By: AJM on Thu, 25 October 2007 05:40
		Re: getInitialDataMultiple does not deal with ') OR (' in $where parameter By: alrobertson on Tue, 30 October 2007 16:53
		Re: getInitialDataMultiple does not deal with ') OR (' in $where parameter By: AJM on Tue, 30 October 2007 20:27
		Re: getInitialDataMultiple does not deal with ') OR (' in $where parameter By: alrobertson on Thu, 25 October 2007 12:52

Previous Topic:	using Popup on outer table of MULTI4
Next Topic:	calling ADD2 from LIST1 with $where set.

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 06 17:37:51 EST 2026

Total time taken to generate the page: 0.00874 seconds