Radicore Forum: Bug Reports » calling ADD2 from LIST1 with $where set.

Home » RADICORE development » Bug Reports » calling ADD2 from LIST1 with $where set.

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Re: calling ADD2 from LIST1 with $where set. [message #1165 is a reply to message #1164]

Tue, 06 November 2007 19:32

AJM
Messages: 2388
Registered: April 2006
Location: Surrey, UK

Senior Member

The ADD2 pattern is designed to be called from a LIST2 pattern, not a LIST1. You are mixing your patterns incorrectly, therefore you need to rethink your design.

Tony Marston
http://www.tonymarston.net
http://www.radicore.org

Report message to a moderator

[Message index]

		calling ADD2 from LIST1 with $where set. By: alrobertson on Tue, 06 November 2007 17:41
		Re: calling ADD2 from LIST1 with $where set. By: AJM on Tue, 06 November 2007 19:32

Previous Topic:	getInitialDataMultiple does not deal with ') OR (' in $where parameter
Next Topic:	Audit trail enquiry problem in 2007-11-01 release

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat May 02 22:36:51 EDT 2026

Total time taken to generate the page: 0.07692 seconds