Radicore Forum: Framework » PDF

Home » RADICORE development » Framework » PDF - drawing with lines

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Re: PDF - drawing with lines [message #7910 is a reply to message #7909]

Thu, 20 February 2025 04:25

AJM
Messages: 2378
Registered: April 2006
Location: Surrey, UK

Senior Member

No, it is not possible to take two images and layer one over the other. Maybe you could try merging the two images into a single image in a separate process, and then displaying that single image.

Tony Marston
http://www.tonymarston.net
http://www.radicore.org

Report message to a moderator

[Message index]

		PDF - drawing with lines By: htManager on Fri, 14 February 2025 10:37
		Re: PDF - drawing with lines By: AJM on Sun, 16 February 2025 05:05
		Re: PDF - drawing with lines By: htManager on Sun, 16 February 2025 05:43
		Re: PDF - drawing with lines By: htManager on Wed, 19 February 2025 11:33
		Re: PDF - drawing with lines By: AJM on Thu, 20 February 2025 04:25
		Re: PDF - drawing with lines By: htManager on Thu, 20 February 2025 06:11
		Re: PDF - drawing with lines By: htManager on Thu, 20 February 2025 10:15
		Re: PDF - drawing with lines By: AJM on Sat, 22 February 2025 05:02

Previous Topic:	Tab order in Radicore screen
Next Topic:	Introduction to the Radicore framework

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Feb 22 13:27:50 EST 2025

Total time taken to generate the page: 0.02852 seconds