Radicore Forum
Fast Uncompromising Discussions. FUDforum will get your users talking.

Home » RADICORE » How To » Update 4
Re: Update 4 [message #948 is a reply to message #947] Thu, 12 July 2007 08:44 Go to previous messageGo to previous message
danpoleary is currently offline  danpoleary
Messages: 49
Registered: February 2007
Member
Good morning Tony,

I think I found it, but a I am not sure why it is this way.

when the call is made to my _cm_pre_getData, the $where contains all the selections, but the $where_array only contains the first record. In your sample above, you stripped the sel_publish_key from the $where_array. Should this have been stripped from the $where instead? or, does a problem exists in whic the $where_array is not populated correctly?

Thanks,

Dan

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: javascript not working
Next Topic: Accessing Radicore for the first time
Goto Forum:
  


Current Time: Sat Nov 23 21:45:41 EST 2024

Total time taken to generate the page: 0.01731 seconds