Radicore Forum
Fast Uncompromising Discussions. FUDforum will get your users talking.

Home » RADICORE development » Workflow » Using Pipe3 to model workflow (Petrinet modeling)
Using Pipe3 to model workflow [message #2756] Thu, 21 July 2011 16:09 Go to previous message
grim is currently offline  grim
Messages: 11
Registered: July 2011
Location: Surrey, UK
Junior Member
I was very interested in how workflow is implemented in Radicore and read a bit about Petrinets etc. I downloaded the Pipe3 program to model my workflow. I can create the nets OK and save them, but I cannot open them up again - I get a java error.

I know its outside the scope of Radicore, I was just wondering if anyone else had experienced this and had solved this problem?

Thanks and regards

Graham Jones
 
Read Message
Read Message
Read Message
Previous Topic: creating a system that uses workflow
Next Topic: Workflow implementation question
Goto Forum:
  


Current Time: Thu Mar 28 05:55:41 EDT 2024

Total time taken to generate the page: 0.00934 seconds