Radicore Forum
Fast Uncompromising Discussions. FUDforum will get your users talking.
Home » RADICORE development » Workflow » How to deal with Implicit-Or Split limitations
Re: How to deal with Implicit-Or Split limitations [message #5942 is a reply to message #5938] Wed, 05 October 2016 15:55 Go to previous messageGo to previous message
kong is currently offline  kong
Messages: 90
Registered: December 2011
Member
Not sure I grasp this completely, so based on what I understand here are 2 solutions that approximate the required behavior.

Solution 1:
https://s9.postimg.org/5lszmq0hb/workflow_updated1.png

Solution 2:
https://s12.postimg.org/fojan14n1/workflow_updated2.png

Out of these 2, I think that the second solution is closer to the required behavior.
Any other solutions to get even closer to the business requirement?

[Updated on: Wed, 05 October 2016 16:17]

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Work item assignments
Next Topic: Why is Or-Split (Implicit) is limited only to 2 inwards arcs?
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri May 10 04:01:22 EDT 2024

Total time taken to generate the page: 0.01092 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software