Radicore Forum
Fast Uncompromising Discussions. FUDforum will get your users talking.

Home » RADICORE development » Transaction Patterns » Output 3 - _cm_output_multi()
Re: Output 3 - _cm_output_multi() [message #7669 is a reply to message #7668] Tue, 26 October 2021 06:29 Go to previous messageGo to previous message
htManager is currently offline  htManager
Messages: 415
Registered: May 2014
Senior Member
If I read how you constructed the JOIN's, everything seems to be easy, but if I try to construct my own JOIN's, everything is very hard work for me because I haven't the knowledge and the experience as you have. Every time I have such a challenge I search for solutions in your articles. And mostly I improve a little bit but in very small steps... Wink

This time I succeeded by storing the needed values in $GLOBALS in the _cm_initialise() method for the report title and querying the body occurences in the _cm_output_multi() method with some of these stored values too. The construction of the JOIN's of all tables was too complex for me at the moment. Maybe with the next challenge... Wink

[Updated on: Tue, 26 October 2021 06:29]

Report message to a moderator

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: POPUP3 not working
Next Topic: Using fillcolour in an output3 pattern
Goto Forum:
  


Current Time: Fri Mar 29 07:56:34 EDT 2024

Total time taken to generate the page: 0.01374 seconds