Radicore Forum: Workflow » Using Pipe3 to model workflow

Home » RADICORE development » Workflow » Using Pipe3 to model workflow (Petrinet modeling)

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Using Pipe3 to model workflow [message #2756]

Thu, 21 July 2011 16:09

grim
Messages: 11
Registered: July 2011
Location: Surrey, UK

Junior Member

I was very interested in how workflow is implemented in Radicore and read a bit about Petrinets etc. I downloaded the Pipe3 program to model my workflow. I can create the nets OK and save them, but I cannot open them up again - I get a java error.

I know its outside the scope of Radicore, I was just wondering if anyone else had experienced this and had solved this problem?

Thanks and regards

Graham Jones

Report message to a moderator

[Message index]

		Using Pipe3 to model workflow By: grim on Thu, 21 July 2011 16:09
		Re: Using Pipe3 to model workflow By: AJM on Fri, 22 July 2011 04:52
		Re: Using Pipe3 to model workflow By: grim on Fri, 22 July 2011 11:10

Previous Topic:	creating a system that uses workflow
Next Topic:	Workflow implementation question

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Nov 24 20:06:51 EST 2024

Total time taken to generate the page: 0.00911 seconds